BionX S-series Owner's Manual download pdf (Page 19)

EN-16

ENGLISH

InstruCtIons for use

assistance.Forlessassistancepressbutton‘-’.Whenthereisnoassistancelevelshownandthe

bicycle icon is visible on the screen, there is no assistance. Pedaling is then the same as on a normal

bicycle. To switch from any level of regeneration to the first assist level, press and hold the ‘+‘ button.

WARNING. It is strongly advised to ride away in a straight line when an assistance level is

selected. Never select assistance level 3 or 4 during maneuvering or riding away in a tight corner.

The powerful reaction of motor might take you unawares.

• Regeneration

When the bicycle generates electricity for the battery, the system is in generation mode. The motor

then works as a dynamo. There are four levels of regeneration. The level of assistance is shown by

the bar graph on the left, below the digits for speed. The narrow graph on the display shows the

amount of energy delivered to the battery.

Toincreasetheregenerationlevel,pressbutton‘-’.Forregenerativelevel1pressonce.Pressagain

to increase the regeneration level to a higher level. For a lower regeneration level press button ‘+’.

Toswitchfromanylevelofassistancetothefirstregenerativelevel,pressandholdthe‘-’button.

When the rear brake lever is pulled, the system always switches to generating. The arrow and ‘G’

will show in the display.

• Distance, Odometer, Chronometer, Average speed

The bottom of the display shows distance, odometer, chronometer, and average speed. Press the

button to switch modes. To reset distance, chronometer, or average speed, keep this button

pressedfor2seconds.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

No comments

BionX S-series Owner's Manual Page 19